Comparative Study of TLP250 and IR2132 Driver-Based Inverter for Induction Motor Driving
Article Sidebar
Main Article Content
Abstract
As time progresses, electric motors are used for industrial or commercial purposes. The need for a motor that is robust, simple, and easy to maintain has been answered by creating an induction motor that can handle the purpose. At the beginning of its use, induction motors were more often used at constant speeds. Using an inverter becomes one of the solutions at hand to control the induction motor. Nowadays, most inverters are controlled by the SPWM (Sinusoidal Pulse Width Modulation) method. This method can adjust the output voltage and frequency by setting the carrier signal's frequency value and the reference signal's amplitude. A driver circuit is needed to implement an SPWM-based inverter. This driver circuit is needed to isolate the power circuit from the controller. Moreover, this circuit is also used to increase the microcontroller output signal to trigger the IGBT gate switch. The IR2132 and TLP250 drivers are often used in three-phase inverter applications. These drivers have advantages and disadvantages. This paper discusses the capabilities of these two drivers when applied to a three-phase inverter that functions as an induction motor drive. This inverter-controlled induction motor is advantageous because it can be rotated at a nominal speed and frequency.
Article Details
This work is licensed under a Creative Commons Attribution 4.0 International License.
Journal of Studies in Science and Engineering is licensed under a Creative Commons Attribution License 4.0 (CC BY-4.0).
References
A. Khitrov, A. Khitrov, and K. Kurnikov, "Parameter identification of induction motor drives," in Proc. 28th Int. Workshop on Electrical Drives: Improvement and Reliability of Electrical Drives (IWED), 2021, pp. 0-4, doi: 10.1109/IWED52055.2021.9376382.
G. S. Memon, M. A. Mahar, C. Kumar, M. M. Shaikh, and S. K. Guriro, "Performance analysis of induction motor drive at various conduction modes using 3-phase bridge inverter," in Proc. 21st Int. Multi-Topic Conf. (INMIC), 2018, pp. 206-212, doi: 10.1109/INMIC.2018.8595527.
Y. Yang, S. Member, Q. Zhang, S. Member, and P. Zhang, "A fast IGBT junction temperature estimation approach based on on-state voltage drop," IEEE Trans. Ind. Appl., vol. 9994, no. c, 2020, doi: 10.1109/TIA.2020.3030753.
A. Hadj Dida, M. Bourahla, H. Bulent Ertan, M. Benghanem, and M. E. Benzina, "Three phase inverter speed control of AC drives motor using DSPic microcontroller," in Proc. Joint Int. Conf. - ACEMP 2015 Aegean Conf. on Electrical Machines and Power Electronics; OPTIM 2015 Optimization of Electrical and Electronic Equipment; and ELECTROMOTION 2015 Int. Symp. on Advanced Electromechanical Motion Systems, 2016, pp. 93-101, doi: 10.1109/OPTIM.2015.7426978.
P. C. Moundekar, "Generation of SPWM control pulses for ZSI using dsPIC33EP256MU810," Helix, vol. 8, no. 6, pp. 4453-4459, 2018, doi: 10.29042/2018-4453-4459.
J. W. Makhubele and K. A. Ogudo, "Analysis on basics of modulation techniques for AC drive on efficiency improvements," in 2020 IEEE PES/IAS PowerAfrica (PowerAfrica 2020), 2020, doi: 10.1109/PowerAfrica49420.2020.9219886.
B. Zahra, E. Babaei, C. Cecati, and S. IEEE, "A new topology of cascaded multilevel inverter with reduced number of driver circuit and IGBTs," in Proc. 7th Int. Conf. on Power Electronics and Drive Systems (PEDS), 2017, pp. 5-8.
M. A. Waghmare, K. A. Onkar, and A. V. Jadhav, "dsPIC based implementation of sinusoidal pulse width modulation techniques for multilevel inverters," Int. Res. Jour. Eng. Tech., vol. 6, no. 3, pp. 3958-3962, 2019.
J. H. Choi, Y. S. Noh, and J. H. Kim, "Development of active gate driver to reduce switching loss for inverter system," in Proc. 2019 7th Int. Conf. on Smart Energy Grid Engineering (SEGE 2019), 2019, pp. 167-170, doi: 10.1109/SEGE.2019.8859858.
A. Kundu, Institute of Electrical and Electronics Engineers, Kolkata Section, and PES Chapter, 2020 IEEE International Conference for Convergence in Engineering: proceedings: 5-6 September, Kolkata, India, 2020.
D. Bhowmick, M. Manna, and S. K. Chowdhury, "Online estimation and analysis of equivalent circuit parameters of three phase induction motor using particle swarm optimization," in Proc. 3rd Int. Conf. on Advances in Electrical Engineering (ICAEE), 2016, pp. 1-5.
A. Gupta, R. Machavaram, T. Kshatriya, and S. Ranjan, "Multi-objective design optimization of a three phase squirrel cage induction motor for electric propulsion system using genetic algorithm," in Proc. IEEE Symposium on Product Compliance Engineering (ISPCE), 2020, doi: 10.1109/STPEC49749.2020.9297776.
S. Ojha, C. Sharma, and A. K. Pandey, "Comparative analysis of close loop three level voltage source inverter using sinusoidal pulse width modulation and third harmonic injection method for different loads," in Proc. 2017 2nd IEEE Int. Conf. on Electrical, Computer and Communication Technologies (ICECCT 2017), 2017, doi: 10.1109/ICECCT.2017.8117999.
Y. M. Buswig, H. Albalawi, N. bin Julai, A.-K. bin H. Othman, A. Affam, and O. Qay, "Development and modelling of three phase inverter for harmonic improvement using sinusoidal pulse width modulation (SPWM) control technique," Int. J. Recent Technol. Eng., vol. 8, no. 4, pp. 1897-1902, Nov. 2019, doi: 10.35940/ijrte.C4624.118419.
A. Kumar, R. K. Mandal, R. Raushan, and P. Gauri, "Design and analysis of the gate driver circuit for power semiconductor switches," in 2020 Int. Conf. on Emerging Frontiers in Electrical and Electronic Technologies (ICEFEET 2020), 2020, doi: 10.1109/ICEFEET49149.2020.9186960.
A. Manuel and D. Gopinath, "A simulation study of SiC MOSFET characteristics and design of gate drive card using TLP250," in 2016 Int. Conf. on Next Generation Intelligent Systems (ICNGIS 2016), pp. 4-8, 2017, doi: 10.1109/ICNGIS.2016.7854059.