Experimental Investigation of Single Slope Solar Still by Varying Water Depth and with External Reflector
Article Sidebar
Main Article Content
Abstract
Solar distillation converts salt water into drinkable water, requiring minimal maintenance and energy-saving. However, the desalination process has drawbacks because the system's slow evaporation and condensation rate leads to low freshwater output. Consequently, this method is not widely utilized due to its limited productivity. To address this issue, the study's primary aim was to enhance the productivity of the single-slope solar still. This was achieved by altering the water depth from 3 cm to 6 cm and incorporating an external reflector. The experiments were conducted in Coimbatore, Tamil Nadu, India (11.0168° N, 76.9558° E), with a condensing cover inclined at 11 degrees. The research occurred on varying days between October and November 2023, with water depths ranging from 3 to 6 cm. A comprehensive analysis investigated the influence of different factors on daily production, such as ambient temperature, solar intensity, and inner and outer glass temperatures. The experimental results indicate that the solar still with a single basin, operating at a water depth of 3 cm, achieved the highest water productivity (2.68 L/day) and displayed the best efficiency (30.52%) compared to 4, 5, and 6cm depths. Furthermore, incorporating an external reflector into the solar system still demonstrated a notable elevation in temperature, resulting in a significant boost in water productivity of 3.085 liters per day. This improvement also led to an increase in efficiency of 35.1%.
Article Details
This work is licensed under a Creative Commons Attribution 4.0 International License.
Journal of Studies in Science and Engineering is licensed under a Creative Commons Attribution License 4.0 (CC BY-4.0).
References
M. Yuvaperiyasamy, N. Senthilkumar, and B. Deepanraj, "Experimental and theoretical analysis of solar still with solar pond for enhancing the performance of sea water desalination," Water Reuse, vol. 13, no. 4, pp. 620-633, 2023.
J. Madiouli, A. Lashin, I. Shigidi, I. A. Badruddin, and A. Kessentini, "Experimental study and evaluation of single slope solar still combined with flat plate collector, parabolic trough and packed bed," Solar Energy, vol. 196, pp. 358-366, 2020.
R. Sathyamurthy et al., "Experimental investigations on conventional solar still with sand heat energy storage," Int. J. Heat Technol., vol. 34, no. 4, pp. 597-603, 2016.
L. Ravichandran, D. Rusovs, T. V. Arjunan, S. Vijayan, and M. Matheswaran, "Experimental study of brackish water distillation in single slope solar still using sensible heat storage materials," in Proc. Int. Sci. Conf. Rural Development 2017, 2017, pp. 391-396.
A. R. Singh, A. B. Agarwal, and D. B. Singh, "Sensitivity analysis of double slope solar still having compound par-abolic concentrator integrated ETCs by incorporating heat transfer coefficients, exergy gain and exergy efficiency," Desalin. Water Treat., vol. 276, pp. 13-27, 2022.
S. K. Nougriaya, M. Chopra, B. Gupta, P. Baredar, and H. Parmar, "Influence of basin water depth and energy storage materials on productivity of solar still: a review," Mater. Today Proc., vol. 44, pp. 1589-1603, 2021.
A. Kabeel, M. Abdelgaied, and A. Eisa, "Enhancing the performance of single basin solar still using high thermal conductivity sensible storage materials," J. Clean. Prod., vol. 183, pp. 20-25, 2018.
D. Mugisidi, B. Fajar, and T. Utomo, "The effect of water surface level in sensible heat material on yield of single basin solar still: experimental study," J. Phys.: Conf. Ser., vol. 1373, no. 1, Art. no. 012014, 2019.
T. V. Arjunan, H. Ş. Aybar, and N. Nedunchezhian, "Experimental study on enhancing the productivity of solar still using locally available material as a storage medium," J. Inst. Eng. (India): Ser. C, vol. 98, pp. 191-196, 2017.
M. Elashmawy and M. M. Ahmed, "Enhancing tubular solar still productivity using composite alumi-num/copper/sand sensible energy storage tubes," Sol. Energy Mater. Sol. Cells, vol. 221, Art. no. 110882, 2021.
Q. A. Abed and D. M. Hachim, "Enhancing the productivity of tubular solar still by using the phase change material," Arabian J. Sci. Eng., vol. 46, no. 12, pp. 11645-11660, 2021.
A. Kaushal, R. Varshney, and A. Verma, "Experimental analysis of pyramidal solar still with sponge as absorber," Int. J. Trend Sci. Res. Dev., vol. 2, no. 1, pp. 811-819, 2017.
M. K. Shivhare, Samsher, and A. Kumar, "Impact of various design parameters on solar still systems performance: a review," Aqua—Water Infrastructure Ecosyst. Soc., Art. no. jws2024290, 2024.
S. D. Kanka et al., "Impact of various environmental parameters and production enhancement techniques on direct solar still: A review," Sol. Energy, vol. 267, Art. no. 112216, 2024.
R. Lalitha Narayana and V. Ramachandra Raju, "Effect of flat plate collectors in parallel on the performance of the active solar still for Indian coastal climatic conditions," Int. J. Ambient Energy, vol. 40, no. 2, pp. 203-211, 2019.
A. Kabeel, K. Harby, M. Abdelgaied, and A. Eisa, "A comprehensive review of tubular solar still designs, perfor-mance, and economic analysis," J. Clean. Prod., vol. 246, Art. no. 119030, 2020.
M. Benhammou and Y. Sahli, "Energetic and exergetic analysis of a sloped solar still integrated with a separated heat storage system incorporating phase change material," J. Energy Storage, vol. 40, Art. no. 102705, 2021.
M. M. A. Khan, N. I. Ibrahim, I. Mahbubul, H. M. Ali, R. Saidur, and F. A. Al-Sulaiman, "Evaluation of solar collector designs with integrated latent heat thermal energy storage: A review," Sol. Energy, vol. 166, pp. 334-350, 2018.
E. Alptekin and M. A. Ezan, "A systematic assessment on a solar collector integrated packed-bed sin-gle/multi-layered latent heat thermal energy storage system," J. Energy Storage, vol. 37, Art. no. 102410, 2021.
A. El-Sebaii, M. Ramadan, S. Aboul-Enein, and M. El-Naggar, "Effect of fin configuration parameters on single basin solar still performance," Desalination, vol. 365, pp. 15-24, 2015.
H. N. Panchal, "Performance analysis of solar still with cow dung cakes and blue metal stones," Front. Energy, vol. 9, pp. 180-186, 2015.
O. Rejeb, M. S. Yousef, C. Ghenai, H. Hassan, and M. Bettayeb, "Investigation of a solar still behaviour using re-sponse surface methodology," Case Stud. Therm. Eng., vol. 24, Art. no. 100816, 2021.
A. El-Sebaii, S. Yaghmour, F. Al-Hazmi, A. S. Faidah, F. Al-Marzouki, and A. Al-Ghamdi, "Active single basin solar still with a sensible storage medium," Desalination, vol. 249, no. 2, pp. 699-706, 2009.
T. Ganashree, G. D. Mello, and K. DilipKumar, "Effect of reflector on performance of solar still," Mater. Today Proc., 2023.
J. Karthikeyan, P. Selvaraj, and G. Nagaraj, "Day and night yield performance analysis of solar still for saline water using energetic materials with thermocol insulation," Mater. Today Proc., vol. 33, pp. 4848-4851, 2020.
M. Yuvaperiyasamy, N. Senthilkumar, and B. Deepanraj, "Experimental investigation on the performance of a pyramid solar still for varying water depth, contaminated water temperature, and addition of circular fins," Int. J. Renew. Energy Dev., vol. 12, no. 6, 2023.
H. K. Jani and K. V. Modi, "Experimental performance evaluation of single basin dual slope solar still with circular and square cross-sectional hollow fins," Sol. Energy, vol. 179, pp. 186-194, 2019.
E. Davani, K. Jafarpur, and M. Estahbanati, "A novel analytical performance investigation of varying water depth in an active multi-stage basin solar still in addition to optimization of water depth in a single stage basin still," Available at SSRN 4325772.
D. Kumar, A. Layek, and A. Kumar, "Performance enhancement of single slope solar still integrated with flat plate collector for different basin water depths," in Proc. AIP Conf. Proc., vol. 2273, no. 1, Art. no. 012014, 2020.
K. M. Bataineh and M. A. Abbas, "Theoretical and experimental investigations on single slope solar still," Desalin. Water Treat., vol. 214, pp. 338-346, 2021.